FP 360 sc Oil-in-Water Sensor, 500 ppb, stainless steel body, 10 m (32.8 ft) cable, w/o cleaning unit

FP 360 sc Oil-in-Water Sensor, 500 ppb, stainless steel body, 10 m (32.8 ft) cable, w/o cleaning unit

Product Number: LXV441.99.11102

Ships within 3-5 weeks

Range

Sensor cleaning

Cable Length

Body Material

Price: Contact Us
Talk to an Expert

Continuous oil-in-water monitoring for the right price.

Even the smallest oil traces can impair water quality. The FP 360 sc is specifically designed to detect traces of mineral oils in water while providing the necessary value and benefits for a positive return on investment. The sensor monitors surface water, process water and industrial water continuously. It has a submersible probe design. No tubes, pumps or valves - simply wipe off the sensor's measurement window. Calibrate once every two years. Available in stainless steel or titanium.

Applications:

  • Ballast Water
  • Discharge
  • Industrial Wastewater
  • Petrochemical

Customize and Buy

Your Selection

Product Number: LXV441.99.11102
Ships within 3-5 weeks
Price: Contact Us
Talk to an Expert

Benefits

Lowest Cost of Ownership

The FP 360 sc is specifically designed to detect traces of mineral oils in water while providing the necessary value and benefits for a positive return on investment.

The Right Technology for the Right Price

Due to its unique combination of submersible probe design and UV fluorescence sensing technology, the FP 360 sc delivers the best technology to detect oil in water and is priced below competitive UV fluorescent instruments.

Minimal Maintenance

The FP 360 sc has no tubes, pumps, or valves that can foul or require constant maintenance interventions. Maintenance is limited to occasional wiping of the sensor's measurement window, calibration once every two years, and Xenon lamp replacement every four years.

Reduced Laboratory Testing

While laboratory testing is the ultimate method of measuring oil in water, it is a long and complex process that requires special equipment and trained lab personnel. The FP 360 sc provides a cost-effective, continuous online monitoring solution to maintain process control and avoid oil contamination with minimal laboratory testing.

High Sensitivity and Selectivity

The FP 360 sc can detect and measure polycyclic aromatic hydrocarbons (PAHs) from 1.2 ppb to up to 5000 ppb (µg/L). This is approximately equivalent to a concentration of mineral oil between 0.1 to 150 ppm (mg/L). Furthermore, the FP 360 sc method of detection makes it impervious to interferences by turbid water or natural organic and biological matter that impact online light scattering, UV absorbance, and VIS fluorescence instruments.

Designed for Harsh Conditions

The FP 360 sc is available in stainless steel or titanium housing to provide oil-in-water measurement in the harshest of conditions.
Full Featured “Plug and Play” with Hach Digital Controllers
There’s no complicated wiring or set up procedures with the Hach family of controllers. Just plug the sensor to any Hach digital controller and it’s ready to use because it’s “plug and play.”

Loading

Label Definitions*


Product Life Cycle

*when applicable

Phase Out

Items with this label are at the end of their life cycle and may become obsolete in the future.

Obsolete

Items with this label are obsolete and unavailable through eCommerce.
If applicable, please view Replacement Product above or contact Hach Customer Service for further assistance.